Product Features
Amino functionality for polyisocyanate co-reactants;
For hard but flexible, lightfast, highly reactive two-component polyurethane spray coatings
form of supply
Solvent-free low viscosity liquid
Specification
|
characteristic |
Numerical value |
Units of measurement |
method |
|
Amine value |
240-248 |
mgKOH/g |
Bayer Test Method (2011-0605401-05D) |
|
Viscosity@75°C |
≤100 |
mPa·s |
DIN53019 |
|
Iodine color value |
≤250 |
|
DIN EN 1557 |
Other data*
|
characteristic |
Numerical value |
Units of measurement |
method |
|
equivalent |
about 234 |
|
|
|
Density@20℃ |
about 1.066 |
g/ml |
DIN 51757 |
|
Flash point |
>97 |
% |
DINENISO2719 |
|
water content |
≤0.15 |
% |
DIN51777-1 |
*This data is general information and is not part of the product specification.
Features/Applications
Desmophen® NH 1220 can be used as a co-reactant for Desmodur® N products.
compatibility
In general, Desmophen® NH 1220 is compatible with many polyisocyanates and prepolymers. However, it is necessary to test for compatibility.
store
- Store in original Covestro airtight containers.
- Recommended storage temperature: 0-30℃.
- Avoid moisture, heat and foreign substances
storage time
Provided that the product has been stored in full compliance with the requirements in the "Storage" clause above and handled properly, the product meets the specifications stated in the "Specifications or Characteristic Values" clause above for a period of 6 months from the date of shipment stated on the shipping document or characteristic value (as applicable). The fact that a product exceeds the 6-month period above does not mean that it no longer meets the specifications or the values set in the characteristic values. However, it is recommended that products older than 6 months from the date of shipment be tested prior to use to confirm that they still meet the values set in the specifications or characteristic values. The manufacturer makes no commitments for products older than 6 months from the date of shipment, and does not assume any responsibility or liability for non-conformance to specifications or set values in characteristic values.